5/2/2023 0 Comments Eon timer for gen iii![]() ![]() The tunnel destination address dynamically to the tunnel interface.Ĭommand was modified. Specific 12.2SX release of this train depends on your feature set, platform,Ĭommand was introduced on Cisco ASR 1000 Series Routers.Ĭommand was integrated into Cisco IOS Release 15.1SY.Ĭommand was implemented on the Cisco ASR 901 Series Aggregation ServicesĬonfigure two tunnels to use the same encapsulation mode with exactly the same The address field was modified to accept anĪrgument to allow IPv6 nodes to be configured as a tunnel destination.Ĭommand was integrated into Cisco IOS Release 12.2(30)S.Ĭommand was integrated into Cisco IOS Release 12.2(28)SB.Ĭommand was integrated into Cisco IOS Release 12.2(25)SG.Ĭommand was integrated into Cisco IOS Release 12.2(33)SRA.Ĭommand is supported in the Cisco IOS Release 12.2SX train. Interface and configure the packet source off of the loopback interface. ReferĬonfiguration Guide for more information about AppleTalk Cayman tunneling. ![]() Tunneling is supported on Cisco Catalyst 3850 Series Switches.Įxample shows how to configure the tunnel destination address for Caymanĭevice(config-if)# tunnel source ethernet0ĭevice(config-if)# tunnel destination 10.108.164.19ĭevice(config-if)# tunnel mode cayman ExamplesĮxample shows how to set the tunnel destination address dynamically:ĭevice(config-if)# tunnel destination dynamicĭevice(config-if)# *Nov 22 19:38:28.271: Tunnel notified destination change: dynamic is setĭestination address is configured to be set dynamically, you cannot configure The tunnel destination address without removing the dynamic configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |